On 1/23/2016 2:11 PM, RJ Kanary wrote:
Operating as you are, connecting the Ni-Cads at a different
point in the wiring will probably show no benefit.
Making heat is robbing you of valuable run time. :(
Not all, just the front 30. The rear 60 (and the 30 in the back box) would still interface to the main tractor power bus near the drive motor.
I think if I looked with a temp sensor the inside wires are probably as warm as a toaster oven. Maybe I'll walk out later and check after another run at 3pm or so.
C
RJ On 1/23/2016 1:57 PM, Christopher Zach wrote:I know, but that would slow the tractor down overall. What I need is to be able to keep the auger speed at full while in speed 4/cruise.... C------------------------------------------------------------------------ Avast logo <https://www.avast.com/antivirus> This email has been checked for viruses by Avast antivirus software. www.avast.com <https://www.avast.com/antivirus>