Re: (ET) Removing wheel hubs from transmission

[Rob Brockway <getractor yahoo com>]

 I used heat and a puller years ago.  One side was successful the other 
size I damaged the flange and had to buy a new one from Bill Gun.  PB 
Blaster over a few days may help also.
    On Thursday, November 7, 2024 at 06:19:05 PM EST, Pestka Dennis 
<dennispestka4 hotmail com> wrote:  
 
 Bill Gunn always said to cut them off with a saws all and replace with 
new.

Dennis
Sent from my iPhone

> On Nov 7, 2024, at 4:27 PM, Erv Troyer via Elec-trak <elec-trak cosmos 
> phy tufts edu> wrote:
>
> I got a used 4 speed transmission and installed it in my EGT120 
> tractor. It didn't have the wheel hubs, so I am trying to remove the 
> hubs from the old transmission. I have removed the set screws. and am 
> using a 3 jaw puller, and have heated and pounded then pounded some 
> more. Nothing moves.
>  Has anyone found a way to get these hubs off? I talked to Harold (Clean 
>Power Supply) and he had some suggestions. He has built a heavy duty 
>puller that he uses, but I don't want to make one like this for only the 
>one time I will I will be doing this Erv Troyer Lagrange,INreo43 at aol 
>dot com
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: 
> <http://cosmos.phy.tufts.edu/mhonarc/elec-trak/attachments/20241107/e39982ce/attachment.htm>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://cosmos.phy.tufts.edu/mhonarc/elec-trak/attachments/20241108/2099f874/attachment.htm>