I used heat and a puller years ago.  One side was successful the other size I damaged the flange and had to buy a new one from Bill Gun.  PB Blaster over a few days may help also.

On Thursday, November 7, 2024 at 06:19:05 PM EST, Pestka Dennis <dennispestka4@hotmail.com> wrote:


Bill Gunn always said to cut them off with a saws all and replace with new.

Dennis
Sent from my iPhone

> On Nov 7, 2024, at 4:27 PM, Erv Troyer via Elec-trak <elec-trak@cosmos.phy.tufts.edu> wrote:
>
> I got a used 4 speed transmission and installed it in my EGT120 tractor. It didn't have the wheel hubs, so I am trying to remove the hubs from the old transmission. I have removed the set screws. and am using a 3 jaw puller, and have heated and pounded then pounded some more. Nothing moves.
>  Has anyone found a way to get these hubs off? I talked to Harold (Clean Power Supply) and he had some suggestions. He has built a heavy duty puller that he uses, but I don't want to make one like this for only the one time I will I will be doing this Erv Troyer Lagrange,INreo43 at aol dot com
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <http://cosmos.phy.tufts.edu/mhonarc/elec-trak/attachments/20241107/e39982ce/attachment.htm>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak@cosmos.phy.tufts.edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak

_______________________________________________
Elec-trak mailing list
Elec-trak@cosmos.phy.tufts.edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak