[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) Bearing job, magnet reglue, I hate hubs



"copper" washer sounds like a bronze thrust bearing... don't think I've ever seen one used in the location described.


On 08/05/2019 7:46 pm, Chris Zach wrote:
Slight follow up: I found a copper washer in the parts pile from this,
turns out it goes on the end of the motor shaft and seals the motor.
My guess is then the smaller rubber seal goes on top of that, then the
big rubber seal on that.

It does however rub a little and make a bit of noise at low speed,
which means the second bearing might have gone a tiny bit too far as
well. Hm. I might just let it be for now, could be worse.


--
Jim Coate
www.FreeRangeElectric.com
Home of The Electric Tractor Store