I don't believe there is a good way to boost the voltage output on the
stock chargers, simply because the voltage is built based on the
secondary turns of the transformer and load resistance. Capacitor only
helps as a filter to smooth the output, mostly.
I have one dirty idea, but I don't know what the implications of it
would be, so I'm throwing it out there for everyone else to pick it apart:
Remove one battery out of the circuit and charge for an hour. This
reduces the load resistance a little and gives you some overvoltage to
desulfate the 5 batteries. Then swap the 6th in to perform the same on
the last one, which you may want to do after a normal usage cycle. This
idea allows you to leave all of the components in place without
exceeding their specifications, as long as you don't do it after a deep
discharge that would allow the charger to draw too much current on
either side of the transformer.
Sounds crazy, even to my liking, but it might work!
Chad
------ Original message------
*From: *CZ
*Date: *Wed, Jun 17, 2015 9:29 PM
*To: *elec-trak cosmos phy tufts edu
<mailto:elec-trak cosmos phy tufts edu>;
*Subject:*(ET) Bumping up the charge voltage a tad
Thought: Anyone know of a way to bump the charge voltage of the E20 charger up a bit? I run
the NiCDs, and I really should charge them to 45 volts, not 42 to blow the oxygen off the
plates every once inawhile.Ch <http://awhile.Ch>ange the capacitor a bit? How about a
boost transformer on the input (I could try a variac I have around). I already buck 240 to
208 on my car, I should be able to boost a bit. But how
much?C_______________________________________________Elec-trak mailing listElec-trak cosmos
phy.tufts.eduhtt <mailto: listElec-trak cosmos
phy.tufts.eduhtt>ps://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
<http://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak>
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak