Re: (ET) Mower blades!

[Klein Robert W NPRI <KleinRW Npt NUWC Navy Mil>]

Don't weld.  Just make a bushing that is ever so slightly thinner than the 
blade.  The friction discs should work OK.

-----Original Message-----
From: elec-trak-bounces cosmos phy tufts edu [mailto:elec-trak-bounces 
cosmos phy tufts edu] On Behalf Of Kleinbrahm, Robert
Sent: Wednesday, May 02, 2007 4:10 PM
To: elec-trak cosmos phy tufts edu
Subject: (ET) Mower blades!


I have been toying around with the idea of purchasing a set of Wheel Horse 
14-1/2" mower blades, $ 22.98 @ Glens surplus.  These blades have a center 
whole of ¾" and would need to be modified. I am thinking of filling in the 
whole with my mig welder and then re-drilling for the 5/16" that our decks 
use.

 

Has anyone else been successful in this type of thing?

 

Bob K

 

 

 

 

 

 

 

 

 

 

Robert Kleinbrahm

Senior Network Engineer

First Republic Bank

San Frincisco, CA. 94111

(415) 288.1478

rkleinbrahm firstrepublic com

"Just agree with me and we'll both be right."

 


The information transmitted is intended only for the person or entity to 
which it is addressed and may contain confidential and/or privileged 
material. Any review, retransmission, dissemination or other use of, or 
taking of any action in reliance upon, this information by persons or 
entities other than the intended recipient is prohibited. If you received 
this in error, please contact the sender and delete the material from any 
computer. 

First Republic Bank and its subsidiaries do not take responsibility for, 
or accept time-sensitive instructions sent by email including orders, 
funds transfer instructions or stop payments on checks. All instructions 
of this nature must be handled by direct communication, not email.

We reserve the right to monitor and review the content of all email 
communications sent or received. Emails sent to or from this address may 
be stored in accordance with regulatory requirements.