I have been toying around with the idea of purchasing a set of Wheel
Horse 14-1/2” mower blades, $ 22.98 @ Glens surplus. These blades have
a center whole of ¾” and would need to be modified. I am thinking of
filling in the whole with my mig welder and then re-drilling for the
5/16” that our decks use.
Has anyone else been successful in this type of thing?
Bob K
//Robert Kleinbrahm//
//Senior Network Engineer//
//First Republic Bank//
//San Frincisco, CA. 94111//
//(415) 288.1478//
//rkleinbrahm firstrepublic com <mailto:rkleinbrahm firstrepublic com>//
//"Just agree with me and we'll both be right."//
The information transmitted is intended only for the person or entity
to which it is addressed and may contain confidential and/or
privileged material. Any review, retransmission, dissemination or
other use of, or taking of any action in reliance upon, this
information by persons or entities other than the intended recipient
is prohibited. If you received this in error, please contact the
sender and delete the material from any computer.
First Republic Bank and its subsidiaries do not take responsibility
for, or accept time-sensitive instructions sent by email including
orders, funds transfer instructions or stop payments on checks. All
instructions of this nature must be handled by direct communication,
not email.
We reserve the right to monitor and review the content of all email
communications sent or received. Emails sent to or from this address
may be stored in accordance with regulatory requirements.
------------------------------------------------------------------------
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak