I have a question for all of you that have done the alltrax
conversion on your tractors. I am almost finished with the E20 conversion
and am wondering if any of you have kept the CB-3 breaker in your
conversions? The CB-3 is an internal breaker in the main motor that has
the two leads #5 & #25 coming out of the motor connector plug along with
the field wires #62 & #36 on the motor. If you have kept this
internal breaker, how did you end up wiring it? I believe that the
Alltrax schematic doesn’t show it, nor does the controller seem to need
it to function. I’m just leery of snipping too many wires that are
not required for this installation to function.
Thanks,
Bob K.
Bob Kleinbrahm
Senior Network
Engineer
First Republic
Bank
San Francisco,
CA. 94111
415 288-1478
rkleinbrahm firstrepublic com
The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer.
First Republic Bank and its subsidiaries do not take responsibility for, or accept time-sensitive instructions sent by email including orders, funds transfer instructions or stop payments on checks. All instructions of this nature must be handled by direct communication, not email.
We reserve the right to monitor and review the content of all email communications sent or received. Emails sent to or from this address may be stored in accordance with regulatory requirements.
|
|