|
Some random pictures will come to you by email in a few minutes as you
requested to illustrate the upgrade of my precious Elec-Trak E20. The pictures
were taken a few minutes ago and have not been checked out too closely so
please let me know if you receive them OK. Picture 001 Shows fiber
optic light output from AllTrax DCX300 ET as seen dash. 02
Large available hot water heater
switch box to hold pedal pot. 03
Another view of speed control box. 04
Large view of pot box. 05
Pot box opened to show the Curtis
pot mechanism without alterations. 06
Shows very clean battery
tops-bolts cut off-original cables used. 07
View under hood. Note missing wire
to accessory plug which burned. 08
Main cutoff-new double contactor
to cutoff charged when controller on. 09
Arrow points to Dash Pot. Note
Cruise Control light lit up. 10
A better view of Dash Pot. Note
small fiber optic light on. 11
Shows old garage door cable
connected to speed controller. 12
General Left side view. 13
Front view. 14
Last pic
shows small clamp holding cable to pedal. |