Re: (ET) steering stuff

[Pieter <plitch attglobal net>]

My E-15 is a dual pulley setup.  Can't say that it was a factory installed 
setup, since it was equipped with a heavy loader for most of its life, and 
could have been installed by a dealer or owner to improve performance.


At 09:30 AM 6/17/2004, Christopher Zach wrote:
> If it has a thermal switch it might be an E20 motor. Still, why only one 
> drive pulley? This is the second time I've heard of this (one pulley and 
> belt) were all E15's single belt drive with the only dual belt being the E20?
>
> How much for it? I'd be interested for a future tiller conversion.
>
> Chris
>
>
> neil wrote:
>
> > Sorry, everyone, the two gear sets I've got are gone, Steve and  Marcus 
> > were first in..  I don't have any decals for the panels that are any 
> > good, the panel I have is a piece of moded plastic with words cast in, 
> > all black now, used to have white painted lettering.
> > Have a drive motor  from the e-15, (not checked yet) and  one from an 
> > unknown model.  This is about 4" dia and 16" long with single drive 
> > pulley, it runs ok on 12 volts.. Has a heavy red and black wire plus a 
> > couple light gage wires, maybe thermal switch.
> > wombat
> > _______________________________________________
> > Elec-trak mailing list
> > Elec-trak cosmos phy tufts edu
> > https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
>
>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak