The best thing I found when I was using mine, years ago, was silicone spray! Use it generously on the chute where it pivots/rotates, also. Let it dry for a few minutes before using. It's better than nothing even wet, however! The ET thrower handled wet snow much better than a two stage. I have a two stage on a Gravely, and if it gets wet, you are always digging it out of the chute and the 2nd stage input opening. The higher air volume freezes it to these areas.
Gary Woodard
Kenton, OH
rajrajan001 attbi com wrote:
David,
I just did 6-8" heavy wet snow in North Andover, MA last weekend with
reasonable success. I had to unclog the chute 6-8 times while doing our 250'
driveway.
Best snowthower performance comes with a slick surface anywhere the snow might
touch. Of course this is very hard with our old slightly rusty machines with
flat worn paint. As a group member (remind me who)suggested to me, rubbing
parrafin wax (at grochery or hardware store)all over all the surfaces before
each use gives some slickness to help. Watch out because there are many sharp
edges to mash your knuckles on, best to use thick gloves and do it carefully.
The best solution would be to sand blast the rust spots and prime and paint the
whole inside of the unit, but this is alot of work. I am thinking about doing
this next summer. The same approach (new paint) will make the lawnmower decks
less likely to get grass clogged and stuck to the deck and makes it easy to
clean out. Does anyone recommend a really good paint for these severe dutys?
Also, running with a good charge for maximum motor power helps. I have found
it is best not to stop and start many times to prevent clogging. Go at it as
continuously as possible. Also, make sure you are eating enough snow at a
time, obviously also not letting the ampmeter go beyond the high scale. I also
found this to help. Lastly, getting the chain (and chain&belt if the 36-38"
version)snug and well oiled, and maybe replaced if worn will help.
James
> On 3 Feb 2003 at 7:21, Rob Brockway wrote:
>
> > The snow blower however is somewhat limited ...
>
> I found this to be the case too. The blade works better for me.
>
> But others have reported the opposite. This leads me to believe that either
> there's some variation in the snow throwers, or some wear mechanism that
> makes some of them perform below par, or perhaps both.
>
>
> David Roden - Akron, Ohio, USA
> 1991 Solectria Force 144vac
> 1991 Ford Escort Green/EV 128vdc
> 1970 GE Elec-trak E15 36vdc
> 1974 Avco New Idea 36vdc
> = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
> Thou shalt not send me any thing which says unto thee, "send this to all
>
> thou knowest." Neither shalt thou send me any spam, lest I smite thee.
>
> = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
>
> Est. yearly US cost to safeguard Persian Gulf oil supply: $50 billion
>
> Est. 2001 value of US crude oil imports from Persian Gulf: $19 billion
> -- Harper's Index, April 2002
> = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
>
>