Re: (ET) Shock repair follow-up

["SteveS" <ssawtelle fcc net>]

Well good to know, the tilt up does occur to others. My rear rollers are pretty worn, so that may be contributing to the problem. Mine has the cast aluminum casters and they are nice. It looks like I also had a front roller but it broke off (or was 'removed') at some point.

 

SteveS

E12S

 

 ----- Original Message -----

From: Elie, Larry (L.D.)

To: 'SWS' ; 

Sent: Tuesday, May 07, 2002 9:22 AM

Subject: RE: (ET) Shock repair follow-up

I have seen one mount at the deck pull right through (decks tend to get rusty; you can make a sheet metal brace) and then the other side BEND at the weld without breaking. 

 

The deck does indeed tip up easily.  I have thought about putting a light chain on the bottom and snapping it to the frame, but my real suspicion is that the problem is the back roller is either too small in diameter or doesn't extend all the way to the end.  I have noticed it usually catches near the outside edge.

 

As far as the front casters; I have seen 3 different designs.  The most interesting (to me) was an die-cast-aluminum design that weighed a lot less.  Easier on the lift I suppose.  In addition, two of the decks I have owned had a FRONT roller as well as the back one; 3 did not.  The front roller is about 6" wide and mounted dead-center in front.  These are the decks I kept as they don't dig-in.

 

Larry Elie

 

>