[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ET) E12M
- Subject: Re: (ET) E12M
- From: "David Roberts" <derobert erie net>
- Date: Fri, 28 May 1999 06:24:55 -0400
- Reply-to: "David Roberts" <derobert erie net>
- Sender: owner-elec-trak cosmos5 phy tufts edu
Please remove my e-mail address from getting Elect-Trac email.
From: Dave Stensland <electron megsinet net>
To: elec-trak cosmos5 phy tufts edu <elec-trak cosmos5 phy tufts edu>
Date: Thursday, May 27, 1999 8:39 PM
Subject: (ET) E12M Mower Deck
>I discovered a problem while attaching the last blade on my
>newly-rebuilt E12M mower deck. I'd like to know if anyone can help
>figure out the problem.
>Two out of the 3 blades are perfectly aligned. But the shaft on the
>third one extends down about 1/4" further than then others, effectively
>causing the blade to cut 1/4" too low.
>Is there a trick to this? Right now I think my only option is to take
>the motor apart and move both rotor bearings about 1/4" farther down the
>shaft, effectively causing the blade to come up about 1/4". Am I right?
>Sorry if this sounds stupid, but I've only had my ET baby about a
>month. Please be patient with me while I learn.