Blowtorch? That finally seemed to get my inner race moving here...
C
On 8/4/2019 9:48 AM, Pestka Dennis wrote:
> A friend is also having trouble removing a hub mounted rear wheel from
> an E10M.
> Any tips, tricks, suggestions on removing these ?
>
> Thanks;
> Dennis
> ------------------------------------------------------------------------
> *From:* Chris Zach <cz alembic crystel com>
> *Sent:* Saturday, August 3, 2019 5:47 PM
> *To:* Elec-trak list <elec-trak cosmos phy tufts edu>
> *Subject:* (ET) Bearings for the motors
> Ok, I got a shipment of 6203 and 6205 bearings. The 6203 ones (small)
> seem to be a proper replacement for the top bearing on the fat motors.
> The 6205 bearings seem to be a proper replacement for both bearings on
> this blower motor.
>
> I'll grab a bearing puller kit from HF tomorrow and see if/how they fit.
> But looks pretty good for a start.
>
> Also need to figure out how to pull the stupid hub adapter for mower
> motors without wrecking threads or bending the hub adapter. Real pain in
> the neck.
>
> C
>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak