[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) difference in foot pedal speed controls between E20EC and E20DA



On 4 May 2019 at 17:11, Mike Finck via Elec-trak wrote:

> The difference being 3A is NO and SW4 is NC. 

It's been a while since I looked at an ET speed adjuster, so I might be 
wrong, but in my experience almost all microswitches have both NO and NC 
terminals.  In that case, you'd just move one of the fastons.  Your 
ohmmeter 
will tell you which one to move.  


David Roden - Akron, Ohio, USA

= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = 
Note: mail sent to the "etpost" address will not reach me.  To send 
me a private message, please use the address shown at the bottom
of this page : http://www.evdl.org/help/
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =