On Feb 25, 2017, at 2:25 PM, John Jeno <jjjeno hotmail com> wrote:
Ask if there is a catalyst to drive it to complete cure quicker.
I used valspar enamel hardener from TSC. Works with oil based enamels.
Created a gloss surface and cured to a hard surface in my 50F garage in
about a day. Seven years later still looks great.
Sent from my iPad
On Feb 25, 2017, at 12:26 PM, Rob Brockway via Elec-trak <elec-trak cosmos
phy tufts edu> wrote:
I took the panel cover over the contractors (below the dash) off and had
it scanned to match the color. The color is good. Only down side is the
oil based paint is very slow drying and takes days to dry.
Sent from my iPhone
On Feb 25, 2017, at 12:11 PM, john j casey <jjcrmc verizon net> wrote:
Sorry.
I should have asked if anyone has experience with any of these finishes.
Thanks again
On Feb 25, 2017, at 9:03 AM, john j casey wrote:
Want to re-do my mower and get as close as possible to original mustard
yellow.
Stores don't carry but can get online Rustoleum High Performance V2100
System enamel aerosol in 'Industrial Yellow' V2147838 and also 'Equipment
Yellow' V2148838. There also Rustoleum Industrial Choice 1600 System
enamel in 'School Bus Yellow 1643830.
Thanks, Jack