Re: (ET) Paint

[John Jeno <jjjeno hotmail com>]

Ask if there is a catalyst to drive it to complete cure quicker. 
I used valspar enamel hardener from TSC. Works with oil based enamels.  
Created a gloss surface and cured to a hard surface in my 50F garage in 
about a day.  Seven years later still looks great.  

Sent from my iPad

> On Feb 25, 2017, at 12:26 PM, Rob Brockway via Elec-trak <elec-trak 
> cosmos phy tufts edu> wrote:
> 
> I took the panel cover over the contractors (below the dash) off and had 
> it scanned to match the color.  The color is good.  Only down side is 
> the oil based paint is very slow drying and takes days to dry.
> 
> Sent from my iPhone
> 
>> On Feb 25, 2017, at 12:11 PM, john j casey <jjcrmc verizon net> wrote:
>> 
>> Sorry.  
>> I should have asked if anyone has experience with any of these finishes.
>> Thanks again
>> 
>> 
>>> On Feb 25, 2017, at 9:03 AM, john j casey wrote:
>>> 
>>> Want to re-do my mower and get as close as possible to original 
>>> mustard yellow.
>>> Stores don't carry but can get online Rustoleum High Performance V2100 
>>> System enamel aerosol in 'Industrial Yellow' V2147838 and also 
>>> 'Equipment Yellow' V2148838.  There also Rustoleum Industrial Choice 
>>> 1600 System enamel in 'School Bus Yellow 1643830.
>>> Thanks, Jack
>>> _______________________________________________
>>> Elec-trak mailing list
>>> Elec-trak cosmos phy tufts edu
>>> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
>> 
>> 
>> _______________________________________________
>> Elec-trak mailing list
>> Elec-trak cosmos phy tufts edu
>> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
> 
> 
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak