Is there more than one kind of Elec-trak charger transformer? I might be able to roust one up for you closer than Pittsburgh, but it could be from an E8 or something. It had a black plywood base as I recall...
--Charlie
On 3/11/2016 3:49 AM, David Roden wrote:
I would :
1. Check resistance of all transformer windings (looking for an open).
*nod* Did that last fell. Nothing open, however it is possible that one of the windings has shorted to itself somewhere along the line. I'll see if I can post resistance values.
2. Make sure the cap is the right type.
Yup. It is what was in there when I got it.
3. Check the diodes.
Both were replaced.
I think the transformer is shot. For the short term I'll charge with the little bench supply (2a max), then figure out if I can build or buy a 120v to 50v power supply for it. Getting 48v actually should not be a problem as that's what telco equipment runs at and that would be a lot closer to what a flooded NiCD needs...
Hm.
C
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak