[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) replacing mower arm end bearing



I replaced the whole arm end with a heavy duty rod end bearing welded to a grade 8 bolt with the head cut off and roll pin hole added.

------ Original message------

From: Charlie

Date: Thu, Sep 10, 2015 9:49 AM

To: Elec-Trak;

Subject:(ET) replacing mower arm end bearing

Has anyone ever pressed out and replaced a heim joint (rose joint, rodend bearing) from the end of a front mower deck support arm?  Ihaven't found any mention of this job searching the list archives.There's a little brass pin in the hole in the end of the housing thatcomes out easily enough, but it's not clear if that's an oiler hole ora retaining pin hole.--Charlie_______________________________________________Elec-trak mailing listElec-trak cosmos phy.tufts.eduhttps://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak