[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) drive motor spins, but tractor won't budge



The answer to your last question Mike,is Yes. Since the 2300 contains an open differential, both wheels have torque available, until one wheel loses traction. Then the spinning wheel gets it all.If a hub is loose, one should be able to observe the axle turning inside the hub.If that is not the case it's RDI time.

R emove.
D isassemble.
I nspect.

RJ


On 6/25/2012 10:38 AM, Michael S Briggs wrote:


On Sun, 24 Jun 2012, John J Casey wrote:

Not to put too fine a point on it, each pulley has a set-screw in its
hub.
 If either is loose you go nowhere. Jack


I looked while the tractor was in gear and the motor spinning (making sure I wouldn't get my head crushed if it actually moved). Both pulleys are spinning, and the metal disk on the opposite side of the transmission is also spinning. The fact that the second pulley (the one not connected to the motor itself) is spinning should indicate that the belts are fine. Since the thing on the other side of the transmission is spinning, I assume that means the pulley on the tranny is fine (and the one on the motor should be fine since it's spinning). So, does that only leave the possible problems as loose hub and dead transmission?
    Are both rear wheels powered on these tractors, or only one?

Thanks,
Mike



_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak