[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ET) Wiring up a E12 motor for simple power source
It's been a while but I think I assembled it vertically. Put the
armature into the endshield carefully holding the brushes back and
seating the bearing in. Put the frame over the top and assembly DE.
Mark the endshield position to get it back in proper orientation.
...Walt
-----Original Message-----
From: Christopher Zach [mailto:cz alembic crystel com]
Sent: Thursday, June 23, 2011 4:01 PM
To: elec-trak cosmos phy tufts edu
Subject: Re: (ET) Wiring up a E12 motor for simple power source
On 6/23/2011 3:54 PM, Bob Brandon wrote:
>
> Now for the mechanical problem; how do you restrain the brushes while
> putting the armature back in?
> There is wiring from the brush holder to the field which prevents
> removing the brush holder completely.
On other motors I would tie the brushes back with very thin thread, then
pull the thread out once the armature is in.
C
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak