Re: (ET) E14 Motor

["RJ Kanary" <rjkanary nauticom net>]

         Any epoxy with a good temperature rating will do. If you get stuck, I have a motor from the Wheel Horse version of that unit that doesn't have anything rolling around in it.  I haven't opened  it up, so it's pot luck at it's finest. I'll never use it.

 

RJ

----- Original Message -----

From: Jerry Rhodes

To: Elec-trak Mail List

Sent: Saturday, June 09, 2007 10:00 AM

Subject: (ET) E14 Motor

Good morning folks, tore the motor down on my E14 last nite, nice an clean on the inside, bearings bad, brusches look new, ONE problem 1 of the 6 mag sections is loose, the middle one on one side, what glue would you use to hold her back in place???

 

I had though about useing liq nail an holding her in place with wood blocks aginest the sections on the other side, do you think that would work??

 

I'm open to all an any input you may have, Thank you

 

Jerry NW Ohio   SWAPMEET Sept 14-15-16 2007

---

_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak