Speaking of used parts, does anyone have a shift lever off an E8 or E10
(three speed Peerless)?
My E10 started acting like I was loosing 2nd gear, getting noisy and
jumping
out of gear every once in a while. I figured something might have been
getting worn inside the tranny and the sheet metal "H" pattern shift plate
was not allowing the lever to move far enough. I took that plate off and
it
seemed to help, at least until I was ready to back it into the garage
after
mowing. I tried to go from 2nd to reverse and the dang lever came off in
my
hand. Looks like a fatigue failure of the rod itself just as it goes into
the tranny.
Got my doubts that I can weld this one back together, but I don't have the
tranny torn down yet either. Looks like a lot easier to just replace it
with another one.
Mike in KY
----- Original Message -----
From: "Hump" <hump evgrin com>
To: <elec-trak cosmos phy tufts edu>
Sent: Wednesday, August 02, 2006 7:57 PM
Subject: (ET) Used parts
John,
Could you please resend your request to me? My e-mail provider changed
servers and dropped all of my saved messages. (temporarily, i hope)
--
Stay Charged!
Hump
________________________________________________
Message sent using UebiMiau 2.7.9
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak