[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) 18 volt source



Surpluscenter.com has two 36/48 to 12 volt converters large one is 25 amps small one around 10 amps.  I have seen similar units at JCWhitney also.  I think the fron lift would be happy with a 12 source anyway.

Chris Zach <czach computer org> wrote:
Ok, I love my Elec-trak's new flooded NiCD pack. I haven't even had to
water the cells...

However there is a problem in paradise: NiCDs hate to be tapped. And I
use 18 volts a lot for things.

So I need a 36 volt to 18 volt converter for the front lift (30amps),
rear lift (same) and all my little tools (up to 30a). Any suggestions on
what I could use?

I guess I could just go with a Curtiss GC controller wired to 18 volts
or something. But I'd prefer another suggestion.

Chris

_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak

__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com