Well, it happened sooner than later. I got nailed by my Elec-Trak. Shocked
on the left hand, and quite painful.
Why you might ask? An Elec-trak is only 36 volts. And we all know that 36
volts is safe...
Well, I was checking the temp of one of the shunts in the tractor. It's an
exposed copper strip that was getting very warm under full load. So I put
my hand in the unit and felt the temp with my finger while bringing the
tractor up to speed. Then I cut the power to the motor.
*WHAM*
Felt like my hand was bitten. I pulled back; damn it hurt.
What appears to have happened was that when I stopped the motor my hand
was touching the shunt strip and one of the contactors. My guess is the
transition of motor from on to off created a big EMF voltage spike either
in the field or the armature, right thru CZ's hand.
Moral of the story? You can be bitten by 36 volts. I take precautions on
the Prizm's pack (never pull pack out without first subdividing it into 60
volt segments *BEFORE* it comes out, all paths to the pack isolated,
always use gloves, never reaching over the pack, etc) however this serves
that one can even get bitten on something as innocent as an E20.
Chris
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak