RE: (ET) Electric Chipper/Shredder?

[Klein Robert W NPRI <KleinRW Npt NUWC Navy Mil>]

No Internal or external flywheel, just the rotating inertia of mass.  PTO 
RPM was the same as an IC engine...2400-3600--rpm.

-----Original Message-----
From: Mr23 [mailto:mr23 mn rr com] 
Sent: Wednesday, September 15, 2004 8:25 AM
To: Klein Robert W NPRI; elec-trak cosmos phy tufts edu
Subject: Re: (ET) Electric Chipper/Shredder?


Does it have an integral flywheel?

What RPM did the PTO run at?

----- Original Message ----- 
From: "Klein Robert W NPRI" <KleinRW Npt NUWC Navy Mil>
To: <elec-trak cosmos phy tufts edu>
Sent: Wednesday, September 15, 2004 7:07 AM
Subject: (ET) Electric Chipper/Shredder?


> I recently picked up a ROTO HOE Mdl 500 chipper/shredder.  Originally 
> came
with a 5hp to 12hp IC engine.  Thins one was engine less as it used the
power takeoff pulley from the guys tractor.   Anyway, I have a NOS E-20
drive motor sitting on my shelf and wanted to hear what everyone thought 
about converting it to electric.  Is it as simple as some mounting bolts 
and the appropriately sized pulley?  Then I could just plug it into the 
mower deck/snowblower plug and go to town!
>
> Bob Klein
> Wheelhorse C-185
>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu 
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak