Re: (ET) E-15 Rear Discharge Mower Refurb

[Andrew Poush <agp@???>]

The refurb is progressing.  The large diameter motor has been removed 
from the deck and the rotor separated from the stator.  The lower 
bearing is quite shot - the outer race is rusted to the case endpiece 
and i would bet the inner race is rusted to the shaft.  The upper 
bearing appears ok but I want to replace it while the motor is 
disassembled.

Any suggestions on what tool to use to remove the lower bearing from 
the case endpiece?
What about a tool for pulling the upper bearing off the shaft?  (The 
clearance between the bearing and the commutator is so small.)

Thanks again,
Andy