Re: (ET) Power Disconnect for an E12M

["Steve & Sandy Naugler" <snaugler earthlink net>]

When I bought Bill Gunn's replacement disconnect it cost less than $20 and
included a heavy circuit board to accomodate the fusible link.  I don't
think you can go wrong with the unit Bill sells.

Steve Naugler

----- Original Message -----
From: "Chris Meier" <ChrisM pptvision com>
To: <ThompsonG DFO-MPO GC CA>; <elec-trak cosmos5 phy tufts edu>
Sent: Thursday, April 27, 2000 10:59 AM
Subject: RE: (ET) Power Disconnect for an E12M


>
> I was at a Northern Tool store last night, and they had a Pollak brand
> battery disconnect switch, rated 6-36v, 150amps, for $20.  The ratings
> are a bit low for worst-case conditions.  I don't know the price or
ratings
> of the newer disconnect unit that Bill Gunn sells, but you'd probably be
> better off using the unit he sells (based on past recommendations).
>
> On Thursday, April 27, 2000 6:51 AM, ThompsonG DFO-MPO GC CA
> [SMTP:ThompsonG DFO-MPO GC CA] wrote:
> > So, Here is the question/problem?
> > I need or would like to find a Power Disconnect for an E12. At the
moment
> I
> > just have a hole on the side of the tractor where it should go and a
green
> > wire dangling from the Amp Meter. If you have one you are willing to
sell
> > me. Please E-mail me
> >
> > I was digging around in my new E12 and discovered a lose green wire
under
> > the dash. It came from the Amp meter. After a little while of staring 
> > at
> the
> > schematics and the wiring diagrams in the manual. It finally clicked I
> have
> > no power disconnect. Therefore I have no place to connect the Amp 
> > meter.
> My
> > goal is to restore this ET to nearly, new condition so I need a power
> > disconnect.
> >
> > Geof Thompson B. Sc.
> > Data Management Engineer
> > Canadian Hydrographic Service
> > Central and Arctic Region
> > 867 Lakeshore Road
> > Burlington, Ontario
> > Canada. L7R 4A6
> >
> >
> > Phone (905) 336-4698
> > Fax (905) 336-4698
> > E-mail Thompsong dfo-mpo gc ca
>
>