Re: (ET) Lifts and DC-DC Converters

["David Roden" <etpost drmm net>]

On 22 Dec 2012 at 22:39, Clean Power Supply wrote:

> I usually run the GE lift motors on 24 volts and again, seems to
>  work out fine.

I run mine at 24 volts.  I finally had a motor failure after about 10 
years 
of that, but whether that was from the 33% overvoltage (actually 100%, 
since 
I'm pretty sure it was originally a 12v automotive window lift motor) I 
can't say.
 

David Roden - Akron, Ohio, USA

= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = 
Note: mail sent to the "etpost" address will not reach me.  To send 
me a private message, please use the address shown at the bottom
of this page : http://www.evdl.org/help/
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =