Re: (ET) E14 Runs When It Shouldn't

[William Martin <martinsprinklerdesign yahoo com>]

I had an E12M do the same thing.  It was a motor issue in my case.  I swapped the motor out with a used one I had on hand.  It ran great after that. 

 

Billy

 

From: RJ Kanary <rjkanary consolidated net>
To: G Moses <glm726 verizon net>; et <Elec-trak cosmos phy tufts edu>
Sent: Thursday, April 12, 2012 9:09 AM
Subject: Re: (ET) E14 Runs When It Shouldn't

    When weird things like that start happening in a device that does NOT use the chassis as a tie point,the first thing that comes to my mind is at least two areas of the circuitry have gone ahead and used the chassis as an unintended and potentially dangerous tie point.


RJ

On 4/12/2012 8:46 AM, G Moses wrote:
> My E14 will still run (but at very reduced power) even if I remove one of the wires from the seat switch. Could there be a simple explanation for this?
>
>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak

_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak