Open CB-2 would
do it.It's on the negative side of the circuit and would prevent
charging.
RJ
Chris Zach wrote:
So
I sat down over the week and put the E15's charger back together. Very
slow job, I had to re-cut a new wood plate, use the router to
countersink holes for the bolts, clean all of the old bolts, and put
everything back together.
Oddly enough it works. Open circuit voltage is 42 volts, with the
capacitor de-tached it's 34 volts (which means the cap still works).
And when I hook up a deck motor it spins right up and maintains the 42
volt output (meaning the diodes work).
However putting it in the tractor is not resulting in charging: The two
bigger wires under the front (one was wire 2) showed pack voltage, but
when I connected up the charger and started it I got nothing at the
batteries.
Any idea why?
Chris
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak
|