On 3/15/2011 2:22 PM, David Roden (Akron OH USA) wrote:
I haven't looked at an E20 diagram yet, but as a first guess, I'm
with Rhett
on this one. Even with nothing more than residual field magnetism,
voltage
can rise to truly astonishing levels in a spinning motor, and if I
understand aright, here the field was powered (even if weakened).
Maybe. Let's think about this.
I was rolling down the hill with the throttle up, tractor in L. This
is enough to allow the motor to pick up some speed without allowing it
to run away. Once it was at about 1.5 times full speed I hit the brakes.
Tractor stopped, but slowly. I need to re-adjust the brakes.
I then took off the brake, went to speed 5, then took foot off the
pedal and let it build up to about 1.5 speed. I then put the pedal
down to speed 4, at which point the MOV blew.
It's possible that what happened is that the voltage at the motor went
up higher than the voltage at the meter or the batteries since there
is wire between them and it does have resistance. Also my E20 is
configured with the front power wires directly connected since the
batteries are all in the rear. That might have raised the voltage at
the MOV to a point where it started to short. Once it did, it was gone.
Maybe a bigger MOV.
C
Hitting the pedal while rolling backward, even slowly, has released the
smoke from controller freewheel diodes in road EVs with series
motors. With
a sepex motor, where the armature current isn't reversed through the
field,
I can see how rolling forward downhill at high speed could do something
similar.
Also remember that MOVs lose their ability to absorb surges as they age.
They're rather like sponges; eventually they sort of become saturated.
Disclaimer : I am not an engineer.
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak