[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) Good plug for the E15 board?



Check at RadioShack® for Molex® or similar connectors.Use stranded flying leads from the connector soldered to the card, directly connect the opposite connector end to the tractor's wiring.This was done twenty years ago on my E-20 after the card edge connector split.

    No more eight speeds in Reverse. :)

RJ

Chris Zach wrote:
So I think my E15 board is ready for testing in the tractor. However I am not soldering all the wires to it, only to have to pull it if a component is bad.

Given that the edge connector is gone, what have people been using as an interconnect? I thought DB25, but that might be too small contact wise. Any other thoughts?

Chris

_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak