Re: (ET) Good plug for the E15 board?

["Clean Power Supply" <cleanpower att net>]

 Chris,
 The E15 actually used neither a plug nor soldering to connect those 
wires.The wires each have their own terminal that plugs individually into 
it's slot on the card.I do have the terminals. But maybe you knew all that 
and were looking to improve on that method?
 Sincerely,
 Harold Z.
On January 6, 2011 at 7:55pm -0500, you wrote:
>So I think my E15 board is ready for testing in the tractor. However I
>am not soldering all the wires to it, only to have to pull it if a
>component is bad.
>
>Given that the edge connector is gone, what have people been using as an
>interconnect? I thought DB25, but that might be too small contact wise.
>Any other thoughts?
>
>Chris
>
>_______________________________________________
>Elec-trak mailing list
>Elec-trak cosmos phy tufts edu
>https://cosmos.phy.tufts.edu/mailman/listinfo.cgi/elec-trak

------------------------------------------------------------------
Find out how easy email really is -- without a computer! Visit
www.landel.com or send email to getmailbuginfo landel com
------------------------------------------------------------------