[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) "fuel" gauge + disconnect



 If it is an orange wire with the number 2-02 on it it must be connected 
for the Fuel Level gauge to work.
 Sincerely,
 Harold Zimmerman
 Clean Power Supply
 Ephrata PA
 717-859-4234 
 Supplier of parts for General Electric,New Idea and Wheel Horse Electric 
Tractors.
On November 2, 2010 at 2:20am +0000, you wrote:
>OK so i just wired in a new master disconnect, and fusible link on my 
>E15.. PO had removed the disconnect and tied all four wires together. Not 
>the best thing in the world especially considering there was considerable 
>evidence of melting. Anyhow. When i reattached all the wires i did not 
>connect the smallest one, which i believe goes to the on board charger? I 
>did this because i bought a modern 3 stage charger and plan on completely 
>removing the old one. I went to fire everything up and all circuits are 
>go, except for the fuel gauge. Needle wont move from empty even though 
>the batteries are fully charged. Does the wire i left out need to be 
>connected for the gauge to work?
>
>David
>
>_______________________________________________
>Elec-trak mailing list
>Elec-trak cosmos phy tufts edu
>https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak

------------------------------------------------------------------
Find out how easy email really is -- without a computer! Visit
www.landel.com or send email to getmailbuginfo landel com
------------------------------------------------------------------