Re: (ET) E12S tranny

[Dean Stuckmann <dstuck lakefield net>]

If I recall correctly I had the same problem many years ago. I think I 
just switched the shifter lever so that the original GE one was in the WH 
tranny. It may have been bent a bit differently...

Dean Stuckmann

On May 15, 2010, at 5:55 PM, David Brandt wrote:

> I have this problem too - can't get into high gear since swapping out to 
> the wheel horse transmission.  It's the same one, but the opening is 
> just a little off.  I'll have to grind it out a bit more if I ever 
> really need that gear.  You should definitely enlarge the opening a bit, 
> or maybe just loosening the bolts and scooting the transmission forward 
> a bit will work?
> 
> David Brandt
> 
> 
> --- On Fri, 5/14/10, Tom G. <wavetech superlink net> wrote:
> 
>> From: Tom G. <wavetech superlink net>
>> Subject: (ET) E12S tranny
>> To: Elec-trak cosmos phy tufts edu
>> Date: Friday, May 14, 2010, 9:06 PM
>> So managed to swap out trans with one
>> from parts tractor. No major issues.
>> Put in brake upgrade nice to have brakes that work ! Was
>> able to pull off old brake hub with 2 jaw puller, heat
>> really works to help remove.
>> Unable to shift all the way to the left into neutral, which
>> prevents me from going into D1 or D2.
>> I think the alignment is off compared to other frame even
>> though it is bolted to tab under tractor.
>> Anybody else have this problem ? Should I just cut open
>> more of the shift pattern to allow movement ?
>> 
>> 
>> 
>> _______________________________________________
>> Elec-trak mailing list
>> Elec-trak cosmos phy tufts edu
>> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
>> 
> 
> 
> 
> 
> 
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak