[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ET) Nothing works!
Okay, so I changed out 1RTN and I'm now getting power to the motor in all throttle positions EXCEPT reverse 1. I also still don't get a reading on the charge guage.
-------------- Original message --------------
From: Jim Coate <jbc_lists_NO_REPLY coate org>
> Ah-ha! I think you've found your problem... one little wire on the wrong
> fuse... first note that you are reading extra numbers on your tractor as
> the wires are marked several times at each end. So "32-0132" is really
> 32-01. The extra "32" at the end is the beginning of the next marking.
>
> The simple fix is move wire 4-00 ("4004") from the end fuse to the
> middle fuse. Once that is done, things should behave much better.
>
> You may also have to swap all the wires on the two end fuses to get
> things to match the standard positions and labels. The end fuse labeled
> for the Lift 30-amp slo-blo should have wires 17 and 2-02. Or leave the
> wires and make new labels :-)
>
> Keep in min
d that the relay voltages will not make any sense until the
> fuses are working properly.
>
> Good luck. Time for me to return to the tractor I'm rebuilding.
>
>
> paul mitchell2007 comcast net wrote:
> >
> > 7) *I think this may be where the problem lies*. The wires connected to
> > the fuses are not in sync with those in the manual!
> >
>
>
> --
> Jim Coate, Spencertown, New York
>
> = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
> NOTE: Mail sent to the "NO_REPLY" address will *not* reach me.
> To send me a private message, please follow the directions here:
> http://www.coate.org/contact_jim/
> = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =