[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) Wheel flange!



Can you turn them in to come out the ID?
How about an "Easy-out" ?
You may have to drill them out using a slightly smaller diameter drill and then an Easy-out or drill and re-tap the hole.
 
...Walt
-----Original Message-----
From: elec-trak-bounces cosmos phy tufts edu [mailto:elec-trak-bounces cosmos phy tufts edu]On Behalf Of Kleinbrahm, Robert
Sent: Tuesday, December 19, 2006 10:15 AM
To: Elec-trak cosmos phy tufts edu
Subject: (ET) Wheel flange!

Hi ETers,
 
I have a loose wheel flange on an E-20 tractor that walks in-an-out on the axel.  I have tried everything that I could think of to loosen the allen screws, in order to remove the flange.  The screws won't budge and I am afraid of rounding the heads.  I managed to pull the flange off the axel with a wheel flange remover tool, but ended up scoring the axel in the process.  I have the flange off, but still am at a lose on backing the allens out.  I have tried a torch to the flange, but still have the screws bound tight.  Anybody have another method of attack for this?
 
Thanks,
 
Bob K.
 
 

The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer.

First Republic Bank and its subsidiaries do not take responsibility for, or accept time-sensitive instructions sent by email including orders, funds transfer instructions or stop payments on checks. All instructions of this nature must be handled by direct communication, not email.

We reserve the right to monitor and review the content of all email communications sent or received. Emails sent to or from this address may be stored in accordance with regulatory requirements.