Hi, another quick question that I hope someone can answer for me. I
have forgotten which terminal is the A1 and S2 connectors on my E20
drive motor. I believe that the A1 was the terminal closer to the motor
mounting bracket, had the original red lead wire going to it? Am I
correct in this being the 1 closer to the mount plate? I am trying to
avoid taking the motor down and opening it back up to find this out.
The S2 goes to the motor windings, correct?
Thanks in advance,
Bob
//Bob Kleinbrahm//
//Senior Network Engineer//
//First Republic Bank//
//San Francisco, CA. 94111//
//415 288-1478//
rkleinbrahm firstrepublic com <mailto:rkleinbrahm firstrepublic com>
The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material. Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited. If you
received this in error, please contact the sender and delete the
material from any computer.
First Republic Bank and its subsidiaries do not take responsibility for,
or accept time-sensitive instructions sent by email including orders,
funds transfer instructions or stop payments on checks. All instructions
of this nature must be handled by direct communication, not email.
We reserve the right to monitor and review the content of all email
communications sent or received. Emails sent to or from this address may
be stored in accordance with regulatory requirements.
------------------------------------------------------------------------
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak