I use my C-185 (E-20) dozer blade all the time to work the gravel in my
driveway. I have found that it's much better to drag the blade backward
for a real nice level finished surface. I use the fwd action to remove
high spots AND snow. As for moving the pivot point, you are right to be
weary of digging the blade in and scissoring up. I would think that the
lower the pivot point to the ground the better off you are.
Robert W. Klein II
SSGN Deputy Technical Manager AWS/AWSS
1176 Howell Street
Newport, RI 02841
Phone: 401-832-1948
Toll Free: 1-800-669-6892 Ext. 21948
FAX: 401-832-7877
e-Mail: kleinrw npt nuwc navy mil
-----Original Message-----
From: elec-trak-bounces cosmos phy tufts edu [mailto:elec-trak-bounces
cosmos phy tufts edu] On Behalf Of steves
Sent: Monday, February 20, 2006 7:30 PM
To: et
Subject: Re: (ET) dozer blade and driveway maintenance
Thanks all for the replies and ideas. Changing the angle of the mount
through modifying the bracket, the mounting 'ears', or tire size would
seem to correct the problem, but I'm wondering if it may cause other
problems. Because the mount angles slightly upwards, it does tend to
keep the tires on the ground and perhaps helps to keep the blade from
digging in. Changing the geometry may tend to make the front end of the
tractor to scissor up.
The ideas of the rubber blade tip is good for the snow. For moving
gravel and cutting ditches I'm thinking now of making a bolt-on or
replacement blade tip that hangs lower on the ditch side when the blade
is angled towards the center of the driveway. 'Course I'll have to take
it off when I need a straight blade or plow snow.
This requires more thought......
- SteveS
_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak