Re: (ET) e12 wierd problem

[Garry & Terry Freese <tnlighthouse bellsouth net>]

I would look at the connectors going to the small relays.  Check them all 
but first the Forward and Reverse relay. Over a period of time they get 
brittle and loose.  I had this happen a couple of years ago and had to 
replace a couple of those very small blade connectors.
Garry
East TN

At 02:14 PM 5/9/2005, neil wrote:
> I just dropped the front panel on the e12, looking to see what was causing 
> "no motor run" sometimes, things look ok BUT for whatever reason, if I 
> tilt the panel to about 45 deg  the motor quits, put it back to vertical 
> and stays off.  put the control back to neutral and restart and it 
> runs.  I'm wondering if that big contactor on the panel may be "weak" and 
> can't hold in when it's tipped toward horizpntal - usually sit with the 
> coil horizontal, contact vertical.
>
> any thoughts ?
>
> wombat
>
> _______________________________________________
> Elec-trak mailing list
> Elec-trak cosmos phy tufts edu
> https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak