(ET) RE: Rear wheel flanges

["Kleinbrahm, Bob" <rkleinbrahm firstrepublic com>]

Title: Message

Tom,

 

Thank you very much, this is indeed what is happening on my tractor.

 

Bob

-----Original Message-----
From: Thomas Pattee [mailto:tpattee msn com]
Sent: Monday, April 11, 2005 2:55 PM
To: elec-trak cosmos phy tufts edu; Kleinbrahm, Bob
Subject: Rear wheel flanges

Actually, it was common enough for GE to issue a technical paper/service bulletin on it in January 1971.  In essence, you clean the axle, and then prime/bond the hub to the axle with a resin-based (loctite) product.  Check the GE Product Service Bulletins section under elec-trak.com>general discussions>manuals category.  You need to be a member and logged-in to access this section. 

 

Good luck,

 

Tom

The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer.

First Republic Bank and its subsidiaries do not take responsibility for, or accept time-sensitive instructions sent by email including orders, funds transfer instructions or stop payments on checks. All instructions of this nature must be handled by direct communication, not email.

We reserve the right to monitor and review the content of all email communications sent or received. Emails sent to or from this address may be stored in accordance with regulatory requirements.