Hi
all,
I have recently
purchased a Venture 36 vdc 18" satelite actuator arm to use as an alternate to
the E-20's lift motor. The unit came with a mounting swival clamp assembly
that I was able to mount to the front lift arm shaft with a little
modification. I had to notch out a 1/4 inch cut an inch and a half, down
the center of the welded lift arm extension on the front of the tractor, to
allow space for the actuator clamp swivel to clear the bracket. Works like
a charm and holds the actuator arm securely in front of the tractor. I
mounted the end of the actuator which also has a swiveled hole on the end of it,
to my modified plow blade assembly with a bracket and bolt which slides through
the actuator swivel hole. I tested the actuator by clamping test cables on
batteries 36 volt terminals and wired it to the terminal strip on the actuator
motor inputs. The unit goes in one direction, then by switching the
polarity, in the other direction. I know from recent message threds
that the original lift motor utilizes two coils for its up/down direction and
need to figure out how to design a switch that would reverse polarity for the
actuator. Perhaps a double pole double throw switch with one side wired
opposite the other? Anyone have any ideas on this?
For the mower deck,
I probably will have a short chain attached to the end to allow for the deck to
float properly when in use. I plan on designing a mount bracket for the
rear tiller to use this same actuator unit so that I can simply unbolt it from
the front and onto the back when needed. Has anyone else been successful
in using a satelite actuator arm for a lift on an elec-trak?
Thanks,
Bob
Bob
Kleinbrahm
Senior
Network Engineer
First
Republic Bank
San
Francisco, CA.
415-288-1478
-----------------------------------------------------------------------
The information transmitted is intended only for the person or entity
to which it is addressed and may contain confidential and/or privileged
material. Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited. If you
received this in error, please contact the sender and delete the
material from any computer.