[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: (ET) steering stuff - drive motors - pulleys



My E-15 is dual pulley/belt.
My E-12 was single pulley/belt.

Your unknown motor sounds like E-12 drive motor (I could go measure mine if
you want).
Your motor diameter might be a little smaller.

John

----- Original Message ----- 
From: "Elie, Larry (L.D.)" <lelie ford com>
To: "neil" <wombat dssinternet net>; <elec-trak cosmos phy tufts edu>
Sent: Thursday, June 17, 2004 10:17 AM
Subject: RE: (ET) steering stuff


Black?  That sounds like the motor from the sickle bar mower.  It's
essentially an almost double length
version of the large diameter deck motor, with a second (smaller) set of
magnets inside.  Even uses the
same bearings and brushes.

Larry Elie


-----Original Message-----
From: elec-trak-bounces cosmos phy tufts edu
[mailto:elec-trak-bounces cosmos phy tufts edu]On Behalf Of neil
Sent: Thursday, June 17, 2004 8:12 AM
To: elec-trak cosmos phy tufts edu
Subject: (ET) steering stuff


Sorry, everyone, the two gear sets I've got are gone, Steve and  Marcus
were first in..  I don't have any decals for the panels that are any
good, the panel I have is a piece of moded plastic with words cast in,
all black now, used to have white painted lettering.
Have a drive motor  from the e-15, (not checked yet) and  one from an
unknown model.  This is about 4" dia and 16" long with single drive
pulley, it runs ok on 12 volts.. Has a heavy red and black wire plus a
couple light gage wires, maybe thermal switch.

wombat