RE: (ET) Stick shift lever

["Chapin, Tim" <tchapin umich edu>]

My e12m had the same problem when I got it.  Tried the same thing you 
tried,
found the same answer.  I was able to order a new lever from Bill.  The
problem is the e12m (maybe e12) uses a 3 speed tranny not the common 4 
speed
tranny in the 15's and 20's.  When I talked to Bill, he did say that you
could upgrade to a 4 speed tranny with a conversion kit he sold.  It sounds
like yours was upgraded to a 4 speed.  It also sounded like a few of the
last e12m came standard with the 4 speed tranny.  So you either need a 
shift
lever for the 3 speed tranny or fix the old 4 speed.  If bill was around, 
it
would have been a no brainer, order the new lever.

-----Original Message-----
From: elec-trak-bounces cosmos phy tufts edu
[mailto:elec-trak-bounces cosmos phy tufts edu] On Behalf Of Bruce Conner
Sent: Tuesday, June 08, 2004 6:42 PM
To: elec-trak cosmos phy tufts edu
Subject: (ET) Stick shift lever

I'm replacing the transaxle on my E12M with a spare I got a while back. 
 All went well up to the point where I tried to take the good shift 
lever from my "old" unit and put it on my "new" one.  They aren't the 
same!  Arrrgh!  The lever on the "new" transaxle was busted off right at 
the tranny, which is why I needed to swap them. I need to tap into the 
knowledge base here and ask about the various models of transaxles.

The one I need the shift lever for has cast iron (?) tubes over the 
axles and they bulge at the end and hold a ball bearing assembly.  The 
shifting lever has a longer lower section (inside the transaxle) than 
the "old" one, and the lever pivot housing is larger as well.  Is this 
enough clues or do I need to do some sleuthing?  There is a pretty good 
lawn mower and tractor place in town, so they might have the stuff for a 
Peerless if they get a part number.

Since I have you here, anybody know about replacing the bronze axle 
bushings on my "old" transaxle? They are all shot to hell and that's why 
the other one was going in.  Part numbers and hints are most welcome. 
 Oh Bill!  Why have you left us??

Bruce Conner



_______________________________________________
Elec-trak mailing list
Elec-trak cosmos phy tufts edu
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak