Apparently, one can put four 10lb weights plus one 25lb weight on each
side. I quote: "Use 10-pound plates inside the wheel and 25-pound plates after clearing the outer edge of the wheel/tire. The typical wheel allows four, 10-pound plates and one, 25-pound plate per wheel (plus 5 pounds for each adapter)." The link is: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2574846421&category=11756 The item is slightly more expensive on eBay, I guess because of eBay fees. I am going to see if I can obtain these weights BEFORE I buy the adapters. Richard "Zack" Zachary ThompsonG DFO-MPO GC CA wrote: I just measured - it appears the 8 ½ inch spacing with four holes is theone for my E-15 - and they carry it. I think I'll probably order a set. It appears I could >add 50 lbs per side for a total of 100 additional. Not much, but every little bit helps. Maybe I should just drink a lot more beer and gain the 100 lbs. It would be >more fun.By the way, I turned the rear wheels on my E-15 "inside out" to widen thetrack and increase lateral stability with a bucket loader. Two more things about the wheel weights, 1.) The wheels on and ET are the same as Wheelhorse, may even have been made by Wheelhorse and there is detailed instruction on how to size the wheel. 2.) The site has a freight calculator section and shipping is not too bad if you use FEDEX ground, it was $11.95 to Buffalo. Geof Thompson B.Sc., C.L.S. 905-336-4698 | facsimile / télécopieur 905-336-8916 Thompsong dfo-mpo gc ca <mailto:Thompsong dfp-mpo gc ca > Technical Services | Canadian Hydrographic Service | Services Technique, Service hydrographique du Canada Central & Arctic Region | Région Centrale et de l'Arctique Fisheries and Oceans Canada | 867 Lakeshore Rd, Burlington, (Ontario) L7R 4A6 Pêches et Océans Canada | 867 chemin Lakeshore, Burlington (Ontario) L7R 4A6 Government of Canada | Gouvernement du Canada _______________________________________________ Elec-trak mailing list Elec-trak cosmos phy tufts edu https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak |