Re: (ET) mower blades

["Don Barry" <Don Barry kirbycorp com>]

A better question: If we could get Gatorblade to make some blades for us, 
how many of us would particpate in a GROUP BUY of the blades??

Count me in for 2 sets!

Don Barry
E-15
Houston

>>> Barry Woods <barry woods wright edu> 05/19/03 09:05AM >>>
Has anyone had any luck in finding a set of high-lift blades to fit the 42"
front mount mowing deck?  The blades I ordered from  Bill Gunn have very
little lift and the appearance of the lawn after cutting, even with freshly
sharpened blades, is disappointing.

If my measurements are correct, the blades look to be 14 1/2" in length and
the center hole seems to be about 5/16".  I can find 14 1/2" blades but
nothing with a center hole that small.

I tried mounting two blades on each motor, at right angles with the fiber
washer between them. It did give somewhat better lift and did not seem to
draw anymore current, but no matter how hard I tighten them they will not
stay perpendicular to each other and one will swing around and stop 
directly
under the other after mowing  row or two and them the advantage of two is
lost.

Gatorblades make a mulching blade that does not require a closed deck.  I
figure this would stop some of the back pressure and not draw as much
current as a regular mulching blade would  with the discharge chute blocked
off.  I contacted them (gatorblade.com), but they said they do not have 
that
would fit.

Any suggestions?

Thanks,
Barry


E-15, Dayton, OH

----- Original Message ----- 
From: "Christopher Zach" <czach computer org>
To: <wombat dssinternet net>; <elec-trak cosmos phy tufts edu>; "Dave &
Debbie Barden" <daveb seanet com>
Sent: Monday, May 19, 2003 9:44 AM
Subject: Re: (ET) ryobi


> Well, the Prizm's running voltage is 300 volts at 52 amp-hours. Thus the
> batteries are run in two strings of 25, connected at the ends by
contactors.
>
> Pretty high voltage. However the car can *move* since the batteries can
> deliver 4C without sagging too much (200amp max draw at 300 volts is a 
> lot
> of power).
>
> The Hawker Genesis batteries are probably the best in the business. They
> will crank a V-8 motor without trouble, and I have used one on my garden
> tractor for a year with no trouble. I think the max current you can draw
on
> them is something like a thousand amps. And they weigh only 24 pounds
each.
> Small, compact, high power.
>
> I am thinking of wiring up three of the old ones together and seeing how
far
> they take the Elec-trak (loaded with 6 volt batteries of course :-) Based
on
> my calculations, six of them (two strings of 3) should provide enough
power
> to run the tractor for 30 minutes or so.
>
> Chris
>
>
>
> ----- Original Message ----- 
> From: "Dave & Debbie Barden" <daveb seanet com>
> To: <czach computer org>; <wombat dssinternet net>;
> <elec-trak cosmos phy tufts edu>
> Sent: Monday, May 19, 2003 2:26 AM
> Subject: Re: (ET) ryobi
>
>
> > 54?!  how did you wire them, what's the pack voltage?
> >
> > this wkend I just got a sears cordless mower running that I rescued 
> > from
> the
> > dump.  The 24v charger came in the mail friday, the 12v sealed batts
> measured
> > 2.2volts each!  but after 2 days on the charger came up to 12.7v.  I 
> > ran
> it but
> > only for a coupla seconds.  my charger did the same thing only the 
> > green
> > "ready" led ever lit up.  the red "charging" led never has come on.
> >
> > there's not much grass here in my neighborhood here in town to test it
on
> so
> > I'll have to wait till next wkend when I bring it the farm.  I plan to
use
> it
> > for the lawn in close to the house and flower beds and the E-trac on 
> > the
> other
> > 1/2 ac of lawn.
> >
> > dave
> >
> > > Could also be that after sitting for years the battery is fully
> sulfated.
> > >
> > > If it's a 12 volt 26amp/hour battery then they cost $50 new from
> > > www.surplusev.com. I just bought 54 of them for my electric car;
really
> nice
> > > batteries. Have been thinking of trying to run the E20 with a set of
six
> of
> > > them :-)
> > >
> > > Chris
> > >
> > > ----- Original Message ----- 
> > > From: "Neil Dennis" <wombat dssinternet net>
> > > To: "Elec-trak" <elec-trak cosmos phy tufts edu>
> > > Sent: Monday, May 19, 2003 8:42 AM
> > > Subject: (ET) ryobi
> > >
> > >
> > > > I've got probably the same model, the battery indicated "charged'
> after
> > > > running the charger for several hours but wouldn't start the mower.
> If
> > > > I remember, I found an open connection somewhere, after fixing, the
> > > > mower would run with the charger plugged in but about a minute on
the
> > > > batt.
> > > >
> > > > It sits in my garage, too cheap to try and find a new batt, wonder
> what
> > > > they cost.
> > > >
> > > > wombat
> > > >
> > > >
> > > >
> > >
> > >
> > >
> >
> >
> >
> >
> >
>
>