Re: (ET) Help please

["RJ Kanary" <rjkanary nauticom net>]

 Once the flange is pulled off, an long bolt, threaded into the armature
shaft, and the hub firmly trapped in the press plates, has yet to resist a
20 ton  hydraulic press.


RJ Kanary  Bandi Bros. Inc.
Member TRNi  Since 1998
ASE® Certified Master Auto Technician

rjkanary nauticom net

----- Original Message -----
From: <ThompsonG DFO-MPO GC CA>
To: <elec-trak cosmos phy tufts edu>
Sent: Monday, November 18, 2002 9:47 AM
Subject: (ET) Help please


> Hi
> How do I get the blade hub off the bottom end of a mower motor. It is a
> copper hub on a steel shaft. Is there a trick,  I ve tried a big Snap On
> pullers and even a press. So far all I done is bend the flang.
>
> Thanks
> Geof Thompson B. Sc. CLS
> No trees were killed in the production of this E-mail.
> However, many electrons were severely inconvenienced.
> Data Management Designer
> Canadian Hydrographic Service
> Central and Arctic Region
> 867 Lakeshore Road
> Burlington, Ontario
> Canada. L7R 4A6
>
>
> Phone (905) 336-4698
> Fax (905) 336-8916
> E-mail Thompsong dfo-mpo gc ca <mailto:Thompsong dfo-mpo gc ca>
>
>
>
>