[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: (ET) weight box
- Subject: RE: (ET) weight box
- From: "Joseph Rock" <joseph_rock qwest net>
- Date: Thu, 28 Mar 2002 18:21:45 -0700
- Delivered-to: fixup-elec-trak cosmos phy tufts edu@fixme
- Importance: Normal
- In-reply-to: <3CA381C1.6DFC5E9C@realns.com>
- Reply-to: <joseph_rock qwest net>
- Sender: owner-elec-trak cosmos phy tufts edu
I guess mine's not standard - I just went and measured it and it is: 30" x
8" x 8" with a divider at 11" from the left side that only comes up 7" from
the bottom.
- - joe
E-15
-----Original Message-----
From: owner-elec-trak cosmos phy tufts edu
[mailto:owner-elec-trak cosmos phy tufts edu]On Behalf Of Neil Dennis
Sent: Thursday, March 28, 2002 1:49 PM
To: Elec-trak
Subject: (ET) weight box
the weight box is 8" x 8" x 22" made from about 16 ga steel. Mounts by
two "bayonets" that stick into the slots on the sides of the frame, can
be mounter on either front or back.
Be careful on stalling lift motor, I worked one pretty hard and ended up
rewinding the armature after it burned out. Don't know that it is
hooked up thru any fuse, mine isn't.
wombat