Chris:
My welder plugs into the mower receptacle. I think the inverter did also. Around here I don't comply with the NEC much, when I'm playing. We're a little too rural, yet, unless I go into the place I retired from (cities). All the factories have to meet code around here. The rest is just "logic"!
Gary
Christopher Zach <czach computer org> wrote:
Actually, it's screwed in on my E20; I took it out to show it to the
electricians. I could do that, but then the tractor wouldn't be original :-)
Also I wouldn't be able to plug in the accessories.
Note: When I took the outlet out, the copper wires had some copper sulfate
on them. Came off easily with a bit of contact cleaner and a brush.
Question on the Elec-trak accessories: Did the inverter and the welder plug
into the little 20amp outlet? If so they were probably overloading it.
Chris
----- Original Message -----
From: "Hazen, Dwight L"
To:
Sent: Thursday, March 07, 2002 8:32 PM
Subject: RE: (ET) Tool receptacle
> Drill out the rivets and install a three prong twist lock.
>
> Dwight
>
> -----Original Message-----
> From: Christopher Zach [mailto:czach computer org]
> Sent: Thursday, March 07, 2002 7:19 PM
> To: Gary Woodard; elec-trak cosmos phy tufts edu
> Subject: Re: (ET) Tool receptacle
>
> It's actually a 20amp 250 volt two prong Hubbel plug, and that is the
trick:
>
> No one stocks two prong plugs anymore.
>
> When I brought it to the first supply house, they went "wow, you should
> replace that". Without a ground, the plug pretty much fails every class of
> NEC code. Kind of how you will not find two prong electrical outlets
> anymore; installing one is pretty much a violation of current NEC codes.
>
> That said, they directed me to another place where the manager had one of
> these plugs sitting in his desk. Part of a incorrect order years back; it
> works perfectly.
>
> Chris
>
> ----- Original Message -----
> From: "Gary Woodard"
> To: "Christopher Zach";
>
> Sent: Thursday, March 07, 2002 11:49 AM
> Subject: (ET) Tool receptacle
>
>
>
>
>